Enchanting bridal bouquet with Fleurogami flowers
Instructions No. 571Pick up Paper-Soft-Color with the nudge brush from the sponge in the paint can and color the Coloured paper in circling movements. Then ink the silicone stamp with Paper-Soft-Color and stamp the squiggles onto the inked sheets of paper.
Cut approx. 120 squares, each 7 x 7 cm, from the coloured Coloured paper . Fold the paper squares diagonally, then the two corners towards the top. Fold the two wings outwards to the edge, put both wings up as if they were a bag and then press flat. Fold the tips of the wings downwards, fold the wings inwards, so that a square is formed again. Glue the right wing to the left wing, then join 6 elements with tape-Ribbon to form a flower.
Cut the support wire in half, stick it through the florigami flower and fix a white Pearl in the middle with hot glue. Glue two decorative paper flowers (finished accessory) together, stick a support wire through the middle of each flower and glue an orange Pearl on it
Roll up white Straw silk paper, coarse fibre silk or a lace fabric into a bag, stick the support wire and a Pearl in the middle. With the Cutter cut a hole of approx. 2 cm deep into the plug-in ball, glue a 20 cm long round rod with hot glue into it. Fold the fibre silk lengthwise and pin it around the round rod in folds with strawflower needles underneath the plugging ball. Shorten the wires of the individual pieces and insert them into the ball in rounds close together